ide: change ->set_dma_mode method parameters
Change ->set_dma_mode method parameters to match ->set_dmamode method
used in struct ata_port_operations.
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
diff --git a/drivers/ide/scc_pata.c b/drivers/ide/scc_pata.c
index 23e16e4..e9d4b44 100644
--- a/drivers/ide/scc_pata.c
+++ b/drivers/ide/scc_pata.c
@@ -231,16 +231,15 @@
/**
* scc_set_dma_mode - set host controller for DMA mode
+ * @hwif: port
* @drive: drive
- * @speed: DMA mode
*
* Load the timing settings for this device mode into the
* controller.
*/
-static void scc_set_dma_mode(ide_drive_t *drive, const u8 speed)
+static void scc_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
{
- ide_hwif_t *hwif = drive->hwif;
struct scc_ports *ports = ide_get_hwifdata(hwif);
unsigned long ctl_base = ports->ctl;
unsigned long cckctrl_port = ctl_base + 0xff0;
@@ -254,6 +253,7 @@
int offset, idx;
unsigned long reg;
unsigned long jcactsel;
+ const u8 speed = drive->dma_mode;
reg = in_be32((void __iomem *)cckctrl_port);
if (reg & CCKCTRL_ATACLKOEN) {
