| OPTIONS: | |
| -soc [soc] | |
| Specifies the SOC to build the image for. | |
| This option is mandatory. | |
| -rev [revision] | |
| Specifies the SOC's revision to build the image for. | |
| Valid values for revision are A0 and B0. | |
| For now, only socs QX and QM have B0 revisions. | |
| When not specified, default revision is A0. | |
| -commit | |
| Prints the commit used to build the mkimage. | |
| -dev [device] [page_size] | |
| Specifies the boot device. | |
| The valid device values are: flexspi, sd and nand. | |
| The page size argument is available only for B0 revisions when device is 'nand'. | |
| The valid page size values are: 4K, 8K or 16K. | |
| -append [filename] | |
| Specifies the container blob file to be appended as is. | |
| -out [filename] | |
| Specifies the output file for the generated and appened containers. | |
| -c, --container | |
| Create new container to be appended. | |
| -flags [value] | |
| Specifies flags for the new container. | |
| The value needs to be a 32bit value in hex. | |
| -dcd [filename] | |
| Specifies the DCD image to be appended to the new container. | |
| Not applicable for socs QX and QM revision B0. | |
| -scfw [filename] | |
| Specifies the SCFW image to be appended to the new container. | |
| -scd [filename] | |
| Specifies the SCD image to be appended to the new container. | |
| Applicable only for non B0 revisions. | |
| -csf [filename] | |
| Specifies the CSF image to be appended to the new container. | |
| Applicable only for non B0 revisions. | |
| -ap [filename] [core] [address] | |
| Specifies the AP image to be appended to the new container. | |
| Valid core values for this image are 'a35', 'a53' and 'a72'. | |
| The address represents the start address and needs to be a 32bit value in hex. | |
| -m4 [filename] [core] [address] | |
| Specifies the M4 image to be appended to the new container. | |
| Valid core values for this image are 0 and 1. | |
| The address represents the start address and needs to be a 32bit value in hex. | |
| -data [filename] [address] | |
| Specifies a data image to be appended to the new container, usually a rootfs image or a kernel image. | |
| The address represents the load address and needs to be a 32bit value in hex. | |
| -fileoff [offset] | |
| Specifies a position to set the file offset of the following image to. | |
| The offset must be greater than file offset at the time and aligned to | |
| sector size. | |
| This is only aplicable for QX/QM revision B0 |